Mechanical behavior of a new type of reinforced concrete composite slab with a joint AITranslate

Basic Information:

DOI：https://doi.org/10.1016/j.cscm.2023.e02773

Chinese Library Classification Number:

Citation Information:

Highlights • A new type of composite slab with a joint was proposed. • The configuration of this new type of composite slab with a joint was determined through experiments. • Nonlinear FEA based on ABAQUS were conducted to reproduce the test of the new type of composite slab. • The research results can be used to guide the design of this new type of composite slab. Composite slabs, consisting of a precast plank and a cast-in-situ concrete topping, are the most commonly used horizontal structural components in prefabricated buildings. In order to solve the problem that the precast plank of composite slab is easy to crack and a lot of vertical supports are needed in its construction, this study proposes a new type of composite slab with a joint. The precast plank of this novel composite slab is fully prefabricated in the midspan area, and concrete is poured on-site only at the surrounding joints. In this paper, the bending performance of three composite slabs with a joint in different shapes of concrete topping and one cast-in-situ slab was investigated. The test results showed that the novel composite slabs with a joint in T-shape and trapezoidal concrete topping had similar properties as the cast-in-situ slab, including bearing capacity and cracking load, which can meet practical requirement. The use of bent-up steel bars and roughening of the interface between the precast plank and topping concrete can ensure effective transmission of internal forces at joint. The bearing capacity of the composite slabs with a joint in T-shape and trapezoidal concrete topping was evaluated using the formula in GB50010–2010, and the experimental values were 1.06 and 1.1 times the theoretical values, respectively, which provides a foundation for the design of two types of composite slabs with a joint. Meanwhile, based on the FEA software ABAQUS, numerical simulation was conducted on the composite slab with a joint in T-shaped concrete topping. The numerical finding exhibit close agreement with experimental results in terms of load-midspan deflection curve and the crack distribution.