Spinodal decomposition and martensitic transformation of the high manganese Mn‒xCu alloys fabricated by additive manufacturing AITranslate

Basic Information:

DOI：https://doi.org/10.1016/j.apmt.2021.101170

Chinese Library Classification Number:

Citation Information:

Mn‒Cu-based shape memory alloys have great potential owing to their excellent shape memory properties, high damping capacity, low production cost, and ease of fabrication. In this study, a selective laser melting (SLM) technique was used to design and manufacture a series of high-manganese Mn‒xCu (x=10–40 wt.%) alloys by blending the elemental powders. Spinodal decomposition and martensitic transformation of the alloys during SLM and heat treatment (HT) processes were investigated and correlated with the tensile, damping, and shape memory properties of the alloys. The results showed that γ‒(Mn, Cu) was the main constituent phase in all of samples subjected to SLM only (hereafter as-SLMed) and the SLMed + HTed Mn‒Cu alloys. The effect of the chemical composition and manufacturing process on the phase structural evolution of the Mn‒Cu alloys were monitored. The spinodal decomposition, martensitic transformation and α-Mn precipitation reactions occurred in the as-SLMed Mn‒xCu samples with x = 15–20 wt.%, x < 30 wt.%, and x < 15 wt.%, respectively. The tensile properties of the as-SLMed Mn‒xCu alloys followed a general downward trend with increasing Mn content, while the corresponding damping capacity and shape memory recovery strain showed the opposite trend. HT can promote spinodal decomposition and martensitic transformation to form an equiaxed γ‒(Mn, Cu) grain, parallel twin plate structure, tweed microstructure, and α-Mn precipitate in the alloys. The SLMed + HTed Mn‒30% Cu alloy displayed a better combination of tensile properties (764, 540 MPa, and 12.5%), damping capacity (tan δ = 0.072 at a strain amplitude of 900 × 10−6), and one-way and two-way (εsme = 1.6% and εtw = 0.7% under the pre-bending strain of 10%) shape memory properties. In addition, the performance of the as-SLMed Mn‒xCu (x = 15–20 wt.%) and SLMed + HTed Mn‒xCu (x = 30 wt.%) alloys is comparable with and even superior to those of multi-component and commercial Mn‒Cu-based alloys, respectively. Graphical abstract Graphical abstract Download : Download high-res image (284KB) Download : Download full-size image